Variable-Primary vs. Primary-Secondary Pumping Strategies
In commercial buildings, energy consumption and occupant comfort are always highly important to building owners. Heating and cooling systems rely on properly designed and executed pumping strategies to deliver on these needs while maintaining building reliability and minimizing cost.
Two common methods of circulating hot or chilled water through a building are Variable-Primary and Primary-Secondary pumping. While both approaches serve the same end goal, they differ in system configuration, control methods, and operation. Understanding the benefits and limitations of each approach can help engineers and owners make smart decisions that benefit a building’s performance, operational cost, and energy efficiency.

Variable-Primary
In a Variable-Primary configuration (See Figure 1), a single loop is used through the source of heating or cooling (boilers or chillers) and through the building to terminal units. These terminal units deliver conditioned air and can include:
Air handling units (AHUs)
Fan Coil Units (FCUs)
Variable Air Volume Boxes (VAVs)
In this setup, only one set of system pumps is needed. The boiler/chiller pumps circulate the water directly to the terminal units. Because there are many factors that will change the demand in a building, it is important that the loop runs at variable flow. Variable frequency drives (VFDs), typically on larger pump motors, or electronically commutated motors (ECMs) on smaller pumps, allow this change in flow depending on system heating/cooling demand.

Figure 1: Hot water piping diagram – Variable-Primary Configuration
Primary-Secondary
In a Primary-Secondary setup (See Figure 2), there are two connected “loops” referred to as the primary and secondary loops. On the primary side lives the source (boilers or chillers). For each unit of source equipment, there is a primary pump that is selected to match the unit’s maximum flow and head loss. The loop runs at a constant flow to ensure the equipment runs efficiently and within the manufacturer’s recommended ranges.
The secondary side consists of larger “secondary pumps”, sized to circulate water to the terminal units throughout the building. Like a Variable-Primary setup, the secondary loop runs at variable flow. The pumps will react to load demands, and increase/decrease flow as necessary.
The two loops are separated in this setup, and operate at different flow rates. Between the two is a common pipe called a zero-pressure bypass. Because the two loops are operating at different flows and pressures, this bypass is needed to isolate each loop from the other. It allows the difference in flow to pass through it, instead of forcing excess water to one side.

Figure 2: Hot water piping diagram – Primary-Secondary Configuration
Key Differences
The main difference between the two strategies is pumping arrangement. While Variable-Primary uses a single set of pumps, Primary-Secondary uses two sets connected via a zero-pressure bypass. Each approach has advantages and disadvantages depending on building size, system requirements and goals for energy efficiency.
Variable-Primary

Primary-Secondary

Conclusion
So, what strategy is better to use? There is no correct configuration to use 100% of the time because selecting the right pumping strategy depends on many factors. It is important that both engineers and owners understand the benefits and limitations of each, as well as the specific needs and requirements of the building.
If discussed in the early stages of a project, the selected system will ensure optimal performance, energy efficiency, and in the end, maintain occupant comfort.

Written by:
Ryan Abbotoni





Comments